Operating Instructions - Pleasant Hearth Merlot COMPACT Manual Del Usuario

operatiNG iNStrUCtioNS

read all instructions Before Use
Check that the heater outlet grill is not covered or obstructed in anyway, and make sure the power to
the unit is switched on.
NOTE: When the heat function is used for the first time, a slight odor may be present. This is normal
and should not occur again unless the heater is not used for an extended period of time.
Control Panel
The control panel is located inside the lower right door on the front panel.
Power
Make sure the POWER switch is OFF. Plug the power cord into a 120 Volt 15 Amp grounded outlet
(see Safety Information on Pages 3 and 4).
Flame Effect: Toggle POWER switch ON. The POWER indicator light will glow. Flame effect will be
visible through the front glass.
Heat (Low): With the POWER switch ON, toggle the LOW (675W) switch ON. The LOW indicator
light will glow. Warm air will blow.
Heat (High): With the POWER switch and LOW switch both ON, toggle the HIGH (1350W) switch
ON. The HIGH indicator light will glow. Hot air will blow.
temperature limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn off. To reset: Unplug the power cord from the outlet.
Wait 5 minutes. With the POWER switch in the OFF position, plug the power cord back into the outlet.
7