Operating Instructions; Care And Maintenance - Pleasant Hearth OFG227BT Manual Del Usuario

OPErATiNG iNsTrUCTiONs

Lighting the burner:
Before each use, inspect all parts.
1. TURN CONTROL KNOB TO "
2. Place a lit match on the lava rocks above the burner.
3. Push and turn control knob counterclockwise
" " HIGH position.
WArNiNG:
If the burner does not ignite within 5 seconds with the
valve open, turn the burner control off and wait for 5
minutes before repeating the lighting procedure. If the
valve is left on, gas will continue to flow out of the burner
and could accidently ignite with a risk of injury.
4. Once the burner is lit, turn the control knob to adjust
the flame to desired height.
5. The normal flame is between 11 inches and 1 inch.
Turning off the burner:
1. Push the control knob and turn clockwise
Disconnecting the propane cylinder:
1. Make sure the control knob is in "
2. Disconnect the cylinder counterclockwise
3. Store the cylinder in a proper location.

CArE AND MAiNTENANCE

• Stubborn stains, discoloration and possibly rust pitting can occur from exposure to harsh outdoor
conditions.
• Be careful not let any powder or solvent come in contact with painted or plastic components as
damage may occur.
• Store the appliance in a cool, dry place away from direct sunlight.
• After the burner and lava rocks are completely cooled down, use a soft brush to clean mild stains,
loose dirt and soil. Wipe with a soft cloth.
• Use a brush with alcohol to clean burner ports. Wait 3 to 5 minutes after cleaning burner before lighting.
• Burner maintenance inspection:
1. Check the surface, burner must be clean and free of rust.
2. Inspect the burner. If the burner tips or swings freely, it needs to be repaired or replaced.
3. Check the screws. If loose, tighten the screws with a wrench before using.
4. Inspect and clean venturi, check carefully for spiders.
5. Inspect and clean burner flume periodically.
• The burner should be checked monthly. If there's evidence of breakage, damage or deformation,
the burner must be replaced prior to the appliance being put into operation. The replacement burner
must be that specified by the manufacturer.
• Use manufacturer approved or supplied replacement parts and accessories only, otherwise it may
void the warranty of this product and result in a hazardous condition.
O
" OFF POSITION.
to the "
O
" Off position and wait 45 minutes until the appliance is cool.
by hand.
7
OFF
to
LOW
4
O
" Off position.
G
F
HIGH
11 in.
1 in.