Powermatic 60C Manual De Operación Y Partes página 13

If the jointer is to be hard-wired to a panel, make
sure a disconnect is available for the operator.
During hard-wiring of the machine, make sure
the fuses have been removed or the breakers
have been tripped in the circuit to which the
jointer will be connected. Place a warning
placard on the fuse holder or circuit breaker to
prevent it being turned on while the machine is
being wired.
Grounding Instructions
This machine should be connected to a
grounded metal permanent wiring system; or to
a system having an equipment – grounding
conductor. In the event of a malfunction or
breakdown, grounding provides a path of least
resistance for electric current to reduce the risk
of electric shock.
Improper connection
grounding conductor can result in a risk of
electric shock. The conductor with insulation
having an outer surface that is green with or
without yellow stripes,
grounding conductor. If repair or replacement of
the electric cord or plug is necessary, do not
connect the equipment-grounding conductor to a
live terminal.
Check with a qualified electrician or service
personnel if the grounding instructions are not
completely understood, or if in doubt as to
whether the tool is properly grounded. Repair or
replace a damaged or worn cord immediately.
IMPORTANT: Make
characteristics listed on the motor nameplate
match those of the power source, and make
sure the circuit on which the jointer will be used
is properly fused and that wire size is correct.
Converting from 230 Volt to 460 Volt
(Three Phase Only)
Consult the wiring diagram inside the starter box
cover. A similar diagram is also included at the
back of this manual. The Jointer must comply
with all local and national codes after being
wired.
1. Replace the current contactor with the 460V
magnetic contactor (part no. PJ882-526C;
purchased separately).
2. Re-connect the incoming leads to the motor
in accordance with 460 volt operation, as
shown in the wiring diagram.
3. If using a plug, install a proper UL/CSA
listed plug suitable for 460 volt operation.
of the equipment-
is the equipment-
sure the electrical
13