Installing Fence Handwheel; Knife Gauge Assembly (Model 60C Only); Storing The Push Blocks; Electrical Connections - Powermatic 60C Manual De Operación Y Partes

Installing Fence Handwheel

Refer to Figure 12.
Install the handwheel (H) onto the shaft, and
tighten the set screw with a 3mm hex wrench.
Knife Gauge Assembly
Refer to Figure 13.
The knife gauge assembly consists of a bar, two
end pieces and two e-clips. Slide the end pieces
onto the ends of the bar as shown, and use a
pliers to push the e-clips into the grooves on the
bar.

Storing the Push Blocks

The two provided push blocks have a magnetic
base – you can attach them to the jointer stand
or any metallic surface, to keep them within
easy reach.

Electrical Connections

Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.
The Jointer is equipped with either a single
phase, 230 volt motor; or a three phase,
230/460 volt motor.
The single phase unit is factory wired for 230
volts. The jointer has a ground plug that looks
like the plug illustrated in Figure 14. Or, you may
"hard-wire" the jointer directly to a service panel.
It is recommended that the single phase jointer
be connected to a dedicated, minimum 20 amp
circuit with a 20 amp circuit breaker or time
delay fuse. Local codes take precedence over
recommendations.
The three phase motor is pre-wired for 230 volt.
It may be re-connected for 460 volts by
changing the connections as illustrated in the
diagram in the starter box (see "Converting from
230 Volt to 460 Volt"). "Hard-wire" the machine
directly to a control panel, and make sure a
disconnect is available for the operator.
It is recommended that the three phase jointer, when operated at 230 volts, be connected to a
dedicated, minimum 20 amp circuit with a 20
amp circuit breaker or time delay fuse. When
operated at 460 volts, connect the jointer to a
dedicated, minimum 15 amp circuit with 15 amp
circuit breaker or time delay fuse. Local codes
take precedence over recommendations.
(model 60C only)
12
Figure 12
Figure 13
(model 60C only)
Figure 14