Proxxon FBS 240/E Manual De Instrucciones página 11

Translation of the Original
GB
Operating Instructions
PROXXON FBS 240/E
Dear customer!
Always keep these operating instructions and the en-
closed safety guidelines within reach.
Only use this device with exact knowledge of it and com-
ply with the instructions and safety guidelines!
This is necessary to ensure safe operation and, secondly,
it simplifies familiarisation with the device and its func-
tions.
Proxxon assumes no liability for the safe function of the
device in the case of:
• handling that does not comply with normal intended
use,
• use for other purposes not mentioned in the manual,
• incorrectly executed repairs,
• failure to heed safety instructions,
• external influences for which the manufacturer is not
responsible
We recommend using PROXXON original spare parts for
all repair and maintenance work.
Repairs should only be performed by qualified skilled per-
sonnel!
Please note: All information contained in these operating
instructions - especially the technical data - corresponds
to the status at the time of printing.
We reserve the right to make further developments in the
interest of technical progress. We wish you every success
with the device.
WARNING!
Read all safety warnings and instructions. Fail-
ure to follow all safety warnings and instruc-
tions listed below may result in electric shock, fire and/or
serious injury.
KEEP ALL SAFETY WARNINGS AND INSTRUCTIONS FOR
THE FUTURE !
Safety warnings common for grinding, sanding,
wire brushing, polishing, carving or abrasive cut-
ting-off operations:
a) This power tool is intended to function as a
grinder, sander, wire brush, polisher, carving or
cut-off tool. Read all safety warnings, instruc-
tions, illustrations and specifications provided
with this power tool. Failure to follow all instruc-
tions listed below may result in electric shock, fire
and/or serious injury.
c) Do not use accessories which are not specifi-
cally designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
d) The rated speed of the grinding accessories
must be at least equal to the maximum speed
marked on the power tool. Grinding accessories
running faster than their rated speed can break and
fly apart.
e) The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately controlled.
f) The arbour size of wheels, sanding drums or any
other accessory must properly fit the spindle or
collet of the power tool. Accessories that do not
match the mounting hardware of the power tool will
run out of balance, vibrate excessively and may
cause loss of control.
g) Mandrel mounted wheels, sanding drums, cut-
ters or other accessories must be fully inserted
into the collet or chuck. If the mandrel is insuffi-
ciently held and/or the overhang of the wheel is too
long, the mounted wheel may become loose and be
ejected at high velocity.
h) Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive
wheels for chips and cracks, sanding drum for
cracks, tear or excess wear, wire brush for loose
or cracked wires. If power tool or accessory is
- 11 -