Demo Mode; Automatic Shutdown - Coltene CanalPro Apex Locator Instrucciones Para El Uso

If Virtual Apex feature is enabled, Virtual Apex mark appears on
the left side of the Apical Zoom image.
When the file tip reaches the Virtual Apex position and during
further advance of the file special beeps appear, clearly distinguis-
hed from regular audio signals.
When the real "APEX" is reached the solid tone is sounded, as usu-
al, and an audio warning signal is activated if the file overpasses
the apex.
„ 6.8. Demo mode
The built-in Demo mode is available to demonstrate operation of the device and to improve the learning
curve of the operator.
6.8.1. Disconnect the measuring cable or the charger from the device if
connected and turn the device Off.
6.8.2. To start Demo Mode, press and hold the
about 1 sec. until the second beep sounds and "Demo" indication
appears on the status bar.
6.8.3. During Demo cycle the operating sequence of the device is
shown on the screen. Press
press button again to resume.
6.8.4. When Demo cycle is completed, it is repeated automatically until
interrupted by the operator.
6.8.5. To exit Demo mode press
until a beep sounds.
Note: If measurement cable is connected to CanalPro Apex Locator during Demo cycle, the
device switches automatically to normal operation mode.
„ 6.9. Automatic Shutdown
CanalPro Apex Locator automatically shuts down after 5 minutes without use. In order to prolong the
battery life, it is recommended to switch OFF the device after measuring by pressing the
26
(On/Off) button for
button to pause the simulation;
button and hold it for about 1 sec.
Picture 15
Picture 16
key (On/Off).