dishwasher-safe. Basic charger should be
cleaned with a damp cloth only (picture
Accessories
Smartphone Holder
• Before each use, make sure mirror, suction
cup surface (10d) and holding brackets
(10a) are always clean and dry (picture
A1). Press your smartphone holder (10)
gently, centered at nose level on the mirror.
Then mount the holder by carefully press-
ing the lever arm (10b) towards the mirror
until it snaps in (picture A2).
Note: Only affix on mirror to ensure safe
and correct conditions. For use in bath-
room only. Do not use in automobiles.
• Always make sure the smartphone holder
is securely mounted on the mirror before
inserting your smartphone. Place your
smartphone (portrait) sideways in
between the holding brackets (10a) by
pressing against one bracket with your
phone and sliding the other bracket to the
side (picture A2). Follow the same proce-
dure to remove your phone again.
• Adjust the overall position for the required
angle by moving the ball joint of the holder
(picture A3). Instructions for the best angle
will be given via app.
• Once done, remove your phone from the
holder. Take off the smartphone holder
by flipping the lever arm back and pulling
the tab carefully (picture A4 1./2.). Affix
smartphone holder with each use again.
• The smartphone holder should be cleaned
with a damp cloth only. Store in clean and
dry place. If not in use, always remove your
smartphone from the holder.
Note: Smartphone width required for usage:
minimum 58 mm, maximum 83 mm.
Caution: Small parts may come off, keep
out of reach of children.
Charging Travel Case
• To charge your handle (5) place it on the
pin in the charging travel case (11) and
connect it to an electric outlet, using the
extra smart plug (12) provided.
• The flashing light (11a) of the charging
travel case indicates that the handle is
charging. Once the handle is fully charged
20
the light turns off. A full charge can take
5
).
up to 12 hours (picture B1).
Note: You may use the USB port (11b)
to charge an electric device while the
charging travel case is plugged in. The
handle can only be charged with the smart
plug (12)/(11c) not via USB port.
• The inner lid of the travel case has a
built-in smartphone holder (11d), which
can hold your smartphone while using
(picture B2). Before use, make sure your
phone fits the stand and keeps stable.
• The removable inlay (11e) of the travel
case is dishwasher-safe (picture
The outer case should be cleaned with a
damp cloth only. Make sure that travel case
parts are completely dry before reassem-
bling and toothbrush/brush heads are dry
before storing in the travel case.
Note: Clean stains on travel case surface
immediately. Store travel case in a clean and
dry place.
Subject to change without notice.
Environmental Notice
Product contains batteries and/or
recyclable electric waste. For
environment protection do not
dispose in household waste, but
for recycling take to electric waste collection
points provided in your country.
Guarantee
We grant 2 years guarantee on the product
commencing on the date of purchase. Within
the guarantee period we will eliminate, free
of charge, any defects in the appliance
resulting from faults in materials or work-
manship, either by repairing or replacing the
complete appliance as we may choose.
This guarantee extends to every country
where this appliance is supplied by Braun or
its appointed distributor. This guarantee
does not cover: damage due to improper
use, normal wear or use, especially regard-
ing the brush heads, as well as defects that
have a negligible effect on the value or oper-
ation of the appliance.
5
).