Technical Specifications - GYS NOMAD POWER PRO 700 Manual Del Usuario

Translation of the original instructions
4.Start the vehicle.
Only jump start when 3 to 4 indicator lights are illuminated.
Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating.
Give two minutes between attempts. The jumping cable can become overheated and detach
as a safety measure.
The jumping cable may overheat. In this case a protection system cuts the tension at the
clamps.
5.When the vehicle is started, remove the jumper cable from the vehicle battery. Leave the vehicle's engine running.
Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it
could lead to damage.
USING AS POWER SUPPLY
Charging Cell Phone or Tablet Instruction
1. Plug the switch cable to Quick Charge output port
2. Select appropriate connector and connect it to your mobile phones or tablet.
3. Touch the switch button
phone/tablet etc.
For power supply to vehicle products or electronics
1. Plug the optional switch cable to 15 V /10 A output port
2. Connect the optional switch cable and vehicle product or electronics
3. Press the switch button
USING AS LED FLASH LIGHT
Press the switch 2 3 seconds to start the LED flash light
There are 4 modes of LED light appear in order (normal. strobe. SOS. off) if you press slightly.

TECHNICAL SPECIFICATIONS

Size: 228 x 99.5 x 38 mm
Weight: 820 g
Battery Capacity: 92,5 Wh
Output: Quick charge (5 V2,4 A; 9 V2 A; 12 V1,5 A); 5 V2,1 A; 15 V10 A
Type-C Max 60 W;12 V jumpstart
Input: Type-C Max 60 W
Full charging time: About 8/9 hours (5V/3A)
Starting current: 600A
Peakcurrent: 1500A
Operating temperature : -20°C ~ 60°C
NOMAD POWER PRO 700
, it can recognise eletronic products's suitable parameters, start to charge for mobile
2
to power supply
2
5
3
.
4
EN
11