Useful Information - Velleman CAMCOLBUL18 Manual Del Usuario

Ocultar thumbs

página de 21

/ 21
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Installation

Refer to the illustration on page 2 of this manual.

• Choose the location for the dome camera, keeping following guidelines in

mind:

• Do not install the camera in locations where extremely high or low

temperatures, high humidity, water vapour or steam, dust or excessive

vibrations may occur.

• Avoid mounting the camera near high electro-magnetic fields as this will

influence image quality.

• Do not aim the camera at the sun or other extremely bright objects or

reflections.

• Best mounting height: at least 2m20.

• Use the included hex key to unscrew both base hex head screws [5] (one

on either side of the base) until the camera can rotate versus the base. Do

not remove the screws completely.

• Rotate the camera while pulling base and camera apart. When internal

protrusions (hex screw) and slots line up, the camera can be removed from

its base.

• Use the base to determine the mounting holes. Make sure to guide the

cables through the base before mounting it on the wall or ceiling.

• Line up protrusions (hex screws) from the camera with the slots in the base

and place the camera back on the base. Rotate the camera to secure it. Do

not tighten the base screws [5] yet.

• Unscrew lens screws [6] (one on either side of the camera) until the lens

can rotate versus the camera body. Do not remove the screws completely.

• Point the camera towards the detection area and connect it to a security

system (not included).

• Tighten both base hex screws [5] until the camera can not rotate versus

the base anymore. Do not force to avoid deformation of or damage to the

housing.

• Rotate the lens until the received image is upright, than tighten both hex

screws [6] until the camera can not rotate versus the camera body

anymore. Do not force to avoid deformation of or damage to the housing.