Ryobi LLCDI1802 Manual De Utilización página 9

EN
FR DE ES IT
OPERATION
TORQUE ADJUSTMENT
See Figure 7.
When using the drill-driver for various driving applications,
it becomes necessary t o i ncrease or decrease the torque
in order to help pre vent the possibility of damaging
screw heads, threads, workpiece, etc.
intensity should correspond to the scre
torque is too high or the scre
may be damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
The torque is greater when the torque adjustment ring
is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
The proper setting depends on the type of material
the size of screw you are using.
BIT STORAGE
See Figure 2.
When not in use, bits provided with the drill can be placed
in the storage areas located on the base of the drill.
INSTALLING BITS
See Figure 8.
■
Lock the switch trigger by placing the rotation selector
in the center position.
■
Open or close the chuc
opening is slightly larger than the bit size
to use. Also, raise the front of the drills lightly to keep
the bit from falling out of the chuck jaws.
■
Insert the drill bit.
■
Tighten the chuck jaws on the drill bit.
NL PT DA SV FI NO
English
In general, torque
w diameter. If the
ws too small, the screws
and
k jaws to a point where the
you intend
RU PL CS HU RO LV
WARNING:
Make sure to insert the drill bit straight into the
chuck jaws. Do not insert
chuck jaws at an angle then tighten. This could
cause the dr ill bit to be
resulting in possible
damage to the chuck.
NOTE: Rotate the chuc
arrow marked LOCK to tighten the chuc
use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
See Figure 8.
■
Lock the switch trigger by placing the rotation selector
in the center position.
■
Open the chuck jaws.
NOTE: Rotate the chuc
arrow marked UNLOCK to loosen the chuc k jaws. Do
not use a wrench to tighten or loosen the chuck jaws.
■
Remove the drill bit.
DRILLING
■
Check the rotation selector f
(forward or reverse).
■
Secure the material
clamps to keep it from turning as the drill bit rotates.
■
Hold the drill firmly and place the bit at the point to be
drilled.
4
LT ET HR SL SK EL
the drill bit into the
thrown from the drill,
serious personal injury
k body in the direction of the
k jaws. Do not
k body in the direction of the
or the correct setting
to be dr illed in a vise or with
TR
or