Barrette 34111554 Instrucciones De Instalación página 4

4.
Assemble Brackets To Uprights:
Bottom Brackets
a. From bottom of upright mark at
location of the bottom of the bottom bracket
(Fig. 7).
b. Align bottom of bracket to this line.
c. Pre-drill holes though upright and aluminum with
⁄ " drill bit. Screw in with two (2) 1" screws as
1
8
provided in the rail bracket kit (Fig. 8).
Top Brackets
a. From bottom of upright mark 32
gates and 38
location of the bottom of the top bracket (Fig. 7).
b. Repeat Step 4b-4c for the top rail bracket (at
line made in Step 4d). Install two (2) 1
c. Test fit the rail panel. Once proper fit is ensured,
press bottom bracket covers onto the ends of
the bottom rail (Fig. 9).
5.
Permanently Attach Rails To Brackets:
a. Press top rail cap and end covers onto the top rail
that was cut in Step 1 onto the top of the panel
(Fig. 10). Press down on the top rail to ensure that
it fits snug onto the panel and that the top rail end
covers are being held in place by the line bracket.
b. Using the holes in the bracket as a guide, drill
two (2)
careful not to drill though the top of the top rail
(Fig. 11). Drive two (2) 1
the holes locking the bracket, panel and top rail
together (Fig. 12).
c. Pre-drill
per bracket) (Fig. 13).
NOTE:
d. Drive a #8 x
holes on side. Screws are included with gate kit.
4
⁄ " for 42" gates. This is the
1
16
⁄ " holes under the bottom of the rail. Be
1
8
⁄
5
⁄ " hole into side of bottom bracket (one
1
8
Make sure the bottom rail is completely
seated in the bottom bracket. Be sure to drill
the hole in the center of the bracket (Fig. 13).
⁄ " screw into the bottom bracket
3
4
⁄ ". This is the
1
4
⁄ " for 36"
1
16
⁄ " screws.
1
2
" screws up through
8
36" Example 36" Example
⁄ "
1
4
Bottom Bracket Cover Bottom Bracket Cover
Top rail cap Top rail cap
End cover End cover
1/8" Hole 1/8" Hole
Fig. 7
32 32 1 1 ⁄ ⁄ " "
16 16
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13