Technical Data; Installation - Zanussi ZOK35901XK Manual Del Usario

Technical Data

If the equipment does not work, please
contact the Technical Service Department
and advise them of the problem, indicating:
1 Serial number (S-No)
2 Appliance model. (Model)
3 Product number (PNC)

Installation

This information is intended for the installer,
as the person responsible for assembly and
electrical connection. If you install the oven
yourself, the manufacturer will not be held
responsible for any possible damage.
Installation must only be performed by a
fully qualified electrician who must ensure
regulations laid down for installation are
observed.
Before Installation. Comments
• To unpack the oven, pull the tab located on
the lower part of the box.
• A niche is required in the kitchen unit as
per the dimensions shown on the figure,
providing a minimum depth of 580 mm.
(See figure describing oven fitting on the
page 17).
• To fit multifunction ovens in their locations,
the back part of the unit, must not have
any projections (reinforcements, pipes,
sockets, etc).
• The adhesive used for the plastic covering
of kitchen furniture must be able to
withstand temperatures up to 85ºC.
Electrical Connection. Legal
Requirements
The installer must check that:
• The voltage and cycles of the mains supply
correspond to that indicated on the rating
plate.
• The electrical installation can stand the
maximum power indicated on the rating
plate.
16
You will find this information on the rating
plate on the lower part of the oven when the
door is opened.
The item that you have bought meets the
European directives on electrical material
safety (73/23/CEE) and electromagnetic
compatibility (89/336/CEE).
• The connection diagram is shown in the
following figure:
• The electrical connection has adequate
earthing in accordance with regulations in
force.
• The connection must be carried out with
an omnipolar switch, of an adequate size
for the current drawn. There must be a
minimum aperture between contacts of 3
mm to enable disconnection in the case of
emergency, cleaning or bulb exchange.
Under no circumstances must the earth
wire pass through this switch.
After connecting the electricity, check
that all the electrical parts of the oven are
working.
www.zanussi.com