How To Replace: Lamp; Troubleshooting; Service Data - Zanussi ZOHKF1X1 Manual De Instrucciones

The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.

11.5 How to replace: Lamp

WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.
The door gasket is dam‐
aged.
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Do not use the oven.
Contact an Authorised
Service Centre.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Step 2
Put a cloth on the bottom of the cav‐
mains.
Problem
End of Cooking - is not
set.
The lamp does not work.

12.2 Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the oven cavity. Do not remove
the rating plate from the oven cavity.
A
Step 3
ity.
Check if...
Set: End of Cooking. Re‐
fer to "Clock functions".
The lamp is burnt out.
ENGLISH 21