Grounding Instructions; Extension Cords - DeWalt DWFP55120 Manual De Instrucciones

ASSEMBLE ACCESSORIES (FIG. 2)
To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An accidental
start-up can cause injury.
Choose the accessory needed.
NOTE: Apply thread seal tape to threads of exposed fittings.
Assemble Female Tire Chuck
1. Ensure regulated pressure gauge read 0 psi.
2. Assemble female tire chuck to hose and tighten securely
with wrenches.
(FIG. 2)
Female
Tire Chuck
Tapered
Nozzles
Hose
End
Inflation
Hose
Needle
Adapter
Assemble Other Accessories
1. Ensure regulated pressure gauge read 0 psi.
2. Attach the hose adapter to hose.
3. Choose the needed accessory. Attach the tapered
nozzles, needle or high flow inflator/deflator adapter body to
the hose adapter.

Grounding Instructions

WARNING: Risk of electrical shock. In the event of a short circuit,
grounding reduces the risk of shock by providing an escape wire for
the electric current. This air compressor must be properly grounded.
The portable air compressor is equipped with a cord having a
grounding wire with an appropriate grounding plug.
1. The cord set and plug (J) with this unit
contains a grounding pin (L). This plug
MUST be used with a grounded outlet
(K).
IMPORTANT: The outlet being used must
be installed and grounded in accordance
with all local codes and ordinances.
2. Ensure the outlet being used has the same configuration as the
grounded plug. DO NOT USE AN ADAPTER.
3. Inspect the plug and cord before each use. Do not use if there
are signs of damage.
4. If these grounding instructions are not completely understood, or
if in doubt as to whether the compressor is properly grounded,
have the installation checked by a qualified electrician.
DANGER: RISK OF ELECTRICAL SHOCK. IMPROPER
GROUNDING CAN RESULT IN ELECTRICAL SHOCK.
• Do not modify the plug provided. If it does not fit the available
outlet, a correct outlet should be installed by a qualified
electrician.
• Repairs to the cord set or plug MUST be made by a qualified
electrician.

Extension Cords

If an extension cord must be used, be sure it is:
• a 3­wire extension cord that has a 3­blade grounding plug, and
a 3-slot receptacle that will accept the plug on the product
• in good condition
• no longer than 50' (15.2 m)
• 14 gauge (AWG) or larger. (Wire size increases as gauge
10
J
K
L