Operation; Maintenance; Cleaning; Grease Filter - De Dietrich DHT1119X Montaje Y Modo De Empleo

Finish the connection of the other end of the exhaust pipe.
If the hood is not in perfect line with the lower edge of the
lateral units, it is possible to adjust the stability by acting on
the fixing screws.
Installing the stopping band (Fig.16)
Apply the stopping band on the hood and fix it with 2 screws
from inside the hood (Fig.18)
Filter version only - Install the charcoal filter/s (Fig.17)
Install the grease filter/s (Fig.18)
Connect the hood to the electric network.

Operation

a. ON/OFF lighting
b. OFF motors
c. - d. - e. Minimum suction power (c.), medium
maximum (e.).

Maintenance

ATTENTION! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.

Grease filter

Fig. 2
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.

Charcoal filter (filter version only)

Fig. 3
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths.
The charcoal filter may NOT be washed or regenerated.
Mounting/removing the carbon filter:
- Extract the pull-out drawer completely.
- Remove the grease filters or the grease filter support
grates.
- Apply one on each side covering both grills protecting the
motor propeller, then turn the filter central handles C
clockwise.
In order to dismantle turn the central handle C anti-
clockwise for each filter.
- Refit the grease filters the grease filter support grates.
CLEANING AND UPKEEP OF YOUR APPLIANCE
(d.),
To keep your appliance in good working order, we
recommend that you use Clearit household products.
Clearit offers you professional products and adapted solutions
for the daily upkeep of your household and kitchen
appliances.
You may find them in conventional retail outlets, along with a
complete line of by-products and consumables.

Replacing lamps

Fig. 4
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
1. press on the lamp cover and release to open.
2. Replace the damaged light bulb.
Only use halogen bulbs of 20W max (G4), making sure
you do not touch them with your hands.
3. Close the lamp cover (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
25
Professional expertise
general public
for the