Water Filter - KENMORE ELITE PreView Grab-N-Go Manual De Uso Y Cuidado

WATER FILTER

NOTE : This refrigerator does not require a filter bypass
plug when the filter is not in place.
It is recommended that you replace the water filter:
• Approximately every six months.
• When the water filter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
1. Remove the old water filter.
• Lift up and remove the lower door bin. Swing
the right end of the water filter out of the
compartment and then grasp and rotate the filter
counterclockwise to remove it from the filter head.
NOTE: Replacing the water filter could cause a small
amount of water to drain. Place a cup under
the filter head to catch any water.
WATER FILTER
2. Replace with a new water filter.
• Insert the new filter into the filter head and rotate it
clockwise until the arrow on the new filter lines up
with the arrow on the filter head. Swing the filter
back into the compartment.
• Assemble the door bin.
3. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5 minutes)
to remove trapped air and contaminants from the
system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad
for cycles of 30 seconds ON and 60 seconds OFF.
4. Press and hold the Water Filter button for 3 seconds
to reset the indicator.
CAUTION: Operating the refrigerator with a water
filter is recommended. However, no bypass filter plug
is necessary if there is no water filter installed.
NOTE: To purchase a replacement filter, visit your local
Sears store, or call 1-844-553-6667.
You may also purchase online at www.kenmore.com
34