Pulse Mode; Purging Air Channels - Jacuzzi SALON Serie Instrucciones Para La Instalación Y El Funcionamiento

Pulse mode

With the blower ON, press the pulse button to cycle
between off and a user defined maximum.
The blower will cycle on (1.5 seconds) to the user defined
maximum (1.5 seconds). All four indicator lights will blink. To
turn off pulse mode, press the (pulse) button.
Press the (+) or (-) button while in pulse mode to set the
maximum intensity level from 50%-100%. There is a 5
second delay after adjusting the maximum intensity level
before changes are observed.
If the wave or pulse functions do not immediately operate
when the wave button or pulse button is pressed, you may
be in chromatherapy lighting mode, you must first press
blower button to switch to blower operation.

Purging Air Channels

The purge cycle is automatic and will reduce excessive accumulation of residual water in the air channels.
There is only one purge per cycle.
Drain Assist Purge
The purge cycle is sensor assisted – two sensors (metal dials) are located near the drain of the bathtub. The sensors
detect the presence and absence of water in the bathtub.
To ensure effective and correct operation of the water sensors, it is important to keep them clean and free from
blockage or objects.
After bathing and following the emptying of the bathing well, the sensors detect a "no water" condition. A five minute
wait time elapses and then the blower is activated. The blower will cycle through a range of speeds for 2 ½ minutes,
during which either 2 or 3 indicator lights will flash at various speeds.
•
The purge cycle will engage even if the blower is not used during bathing.
•
The cycle may initiate more than once if the sensors become wet during any part of the purge operation or during
routine cleaning of the bathtub. This is normal and does not require attention.
Page 20
www.jacuzzi.com
Salon™ Spa Bath
These lights will
be blinking
Installation and Operation