General Operation Information; Blower Operation - Jacuzzi SALON Serie Instrucciones Para La Instalación Y El Funcionamiento

General Operation Information

All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for "fill and drain," which means the bathtub
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Two control panel types are available for the Luxury
Salon Spa series. Refer to details below:
•
J4 Luxury Electronic Control Panel:
Operational instructions for this panel is listed
below.
•
Optional J5 Luxury LCD Control Panel:
Operation instructions for this panel are outlined in
the supplemental guide provided in your warranty
pack. Refer to this document for complete operation
details (P/N GU47000).
Close the drain and fill the bathtub until water is at least
1˝ to 2˝ (25mm to 51mm) above the highest jet (see
water line indicated in the illustration). Do not turn on the
whirlpool system at any time if the jets are not completely
immersed in water. Running the whirlpool system when
there is insufficient water in the bathtub could result
in water spraying outside the bath area. Running the
whirlpool system without sufficient water will damage the
recirculating pump.
When exiting the bathtub, the water level will drop
below the jets which could result in water being
sprayed out of the unit. To prevent this, you must
turn unit OFF before exiting bathtub.

Blower Operation

ON: Press the blower button once to turn the
blower ON.
The indicator light(s) at right will illuminate brightly. The
blower is on a timer and will operate for 20 minutes.
OFF: Press the blower button a second time to turn
the blower OFF.
The last blower setting used is remembered by the
system and will automatically resume upon next
use.
When the blower is turned off, operation does
not immediately cease. There is a delay of 15-20
seconds to allow the blower to cool down. The unit
is shutting down, as indicated by the blinking of
indicator lights.
If in chromatherapy lighting, or whirlpool, mode
(indicator lights are dim), you will need to press the
blower button once to resume blower operation
mode and then a second time to turn the blower
power off.
Page 18
Main Menu
www.jacuzzi.com
Salon™ Spa Bath
Jet Air
J4 Control Panel
POWER
J5 Control Panel
Fill to at least 1˝ to 2˝
above highest jet
Air
These lights will
be blinking
Installation and Operation