Tabla de contenido
Ridge Beam Assembly
2
6
2
6
Layout ridge beam steel support beams to
proper length as in diagram. Line up holes
and bolt steel channels together using bolt set
provided (Note: 4 bolts are to be used to fasten beams
together at the centre and 2 bolts are to be used at either
end to fasten 6" supports). Tighten bolts using
RS2
RS1
Line up 2 ridge beams
2
7
2
7
(2 RB1), apply a bead
of silicone around
joint and slide on
ridge beam exten-
sion cap cover.
RB1
a)
a)
In the event you do not have the recommended five feet
of clearance on one side, you may follow these assembly
instructions as an alternative:
Before Step 29:
Working from the inside of the building, slide roof joiner
panel (JW1) into fascia (FG) at rear and front of building.
Next, install groove panel (PW1) and continue until entire
side of roof is complete. Important: Make sure you slide
roof panels down approximately eight inches from top of
roof to allow the installation of the ridge beam.
Install ridge beam as shown at Step 29 making sure bottom
wing of ridge beam fits under fascia gable (FG).
Slide joiner panel (JW1) nearest outside wall into ridge
beam and continue at Step 32.
7
/
" wrench.
16
Joint Cover
RB1
b)
b)
RS1
RS2
2
2
c)
c)
12
THE BALMORAL
Overlap Distance
of Support Beams
36" (91.44cm)
8
8
Slide steel channels into ridge beams.
2
9
2
9
Add ridge beam. Make
sure bottom wing of ridge
beam fits under fascia
gables.
Overall Beam Length
98 3/4" (250.83cm)
Tabla de contenido
