EGO Power+ ST1210E Manual Del Usuario página 15

9. Holding the spool and spool retainer, grasp one end of the line and pull it to
EN
release the line from the notch in the eyelet. Repeat with the other end (Fig. 25).
25
10. With the spool base facing
downward, align the slots in the
spool retainer with the tabs on the
spool base and press the retainer
evenly down until it snaps into place
(Fig. 26).
NOTICE: Make sure that the tabs on the
spool base snap into place or the spool
will come out during operation.
28
56V LITHIUM-ION CORDLESS STRING TRIMMER — ST1210E
26
Tab
Slot
Install a pre-wound spool
WARNING:
To prevent serious personal injury, remove the battery pack from the
tool before servicing, cleaning, changing attachments or removing material from the
unit.
1. Press the release tabs on the spool base and remove the retainer by pulling it
straight out (Fig. 20).
2. Remove the spool. Use a clean cloth to clean the inner surface of the spool
retainer and spool base.
3. Check the spool retainer, spool and spool base for wear. If necessary, replace the
wear parts.
4. Place a pre-wound spool on the spool retainer.
5. Align the notches of the spool from which the lines protrude with the eyelets in
the spool retainer and position the spool in the retainer (Fig. 24).
6. Holding the spool and spool retainer, grasp one end of the line and pull it to
release the line from the notch in the eyelet. Repeat with the other end (Fig. 25).
7. With the spool base facing downward, align the slots in the spool retainer with
the tabs on the spool base and press the retainer evenly down until it snaps into
place (Fig. 26).
NOTICE: Make sure that the tabs on the spool base snap into place or the spool will
come out during operation.
56V LITHIUM-ION CORDLESS STRING TRIMMER — ST1210E
EN
29