Adjust Door(S) - Kitchen Aid Architect Series Guia De Instalacion

3. Remove one end cap by loosening the nuts and sliding the
end cap off.
A. Bottom rail
B. Nuts
4. Slide the custom panel into the top grille channel and
reattach the end cap.
A. Custom panel
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
A. Top grille
B. Cabinet side trims
C. End cap
D. Top rail
A B

Adjust Door(s)

Door Alignment (36" [91.4 cm] Models)
1. Loosen, but do not remove, the four Torx
mounting screws and the two ¹⁄₄" hex-head mounting screws
in the top hinge.
2. Adjust the top hinge of the door to align it.
3. Tighten the Torx ®† 27 flat-head mounting screws to a torque
of approximately 100 inch-pounds (11.3 Nm).
4. Tighten the ¹⁄₄" hex-head screws.
B
A. Torx ®† 27 flat-head mounting screws
¹⁄₄
"
B. hex-head mounting screws
Door Height Adjustment (42" [106.7 cm] Models)
Use the following steps to adjust the door height, up or down,
after the refrigerator has been leveled.
NOTE: Adjust the right door to the position of the left door first. If
it is necessary to adjust the left door, you must make sure that the
hinged center rail located on the left-hand door does not drag
when closing the door.
1. Open the freezer drawer. Remove the locking plate screw
from the bottom side of the refrigerator door hinge using a
¹⁄₄" open-end wrench.
A B C
A. Bushing
B. Locking plate
2. Remove the locking plate as shown.
†®TORX is a registered trademark of Saturn Fasteners, Inc.
®† 27 flat-head
A
C. Locking plate screw
25