Architect And Overlay Series Factory Panels And Kits (36" [91.4 Cm] Models); Architect Series Custom Side Panels - Kitchen Aid Architect Series Guia De Instalacion

Architect and Overlay Series
®
Factory Panels and Kits (36" [91.4 cm]
Models)
All factory parts are available through your KitchenAid dealer or
by calling KitchenAid Parts and Accessories at 1-800-442-9991.
In Canada, call 1-800-807-6777.
Architect ® Series 72" (183 cm) Top Grille Panel Kit
A 72" (183 cm) wide Top Grille Panel Kit is available. This kit
allows 2 units (one left-hand swing and one right-hand) to be
installed side by side with a single grille.
Stainless Steel (Architect ®
Extended Door Handle Kits
Use extended door handles when additional finger clearance is
needed between the door handles and custom panel. Follow the
kit instructions for installing the door handles.
Matte Aluminum (Overlay Series)
Architect ® Series Custom Side Panels
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
The dimensions shown are actual product dimensions
and may not reflect the needed panel installation
dimensions.
The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick
to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on the rear wall.
Refrigerator
¹⁄₈
24 "
(61.3 cm)
¹¹⁄₁₆
23 "
(60.3 cm)
¹⁄₂
23 "
(59.7 cm)
Series) #W10153554
#4396718
Side Trim
¹⁄₄
(6.35 mm)
³⁄₁₆
"
(4.7 mm)
⁷⁄₃₂
"
(5.5 mm)
¹³⁄₃₂
" (10 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add ⁷⁄₃₂" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
A
2. If the panel is more than ¹⁄₄" (6.35 mm) thick, rout the front
edge to allow the side panel to fit into the trim.
Flush Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall.
A
2. Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.
"
¹¹⁄₆₄
"
(4.5 mm)
⁵⁄₈
"
(15.7 mm)
17