Getting The Beertender Ready; Cooling The Beertender Keg; Installing The Beertender Appliance - Krups BeerTender VB32 Manual Del Usuario

English
The use of kegs "Compatible BeerTender" in the BeerTender system
■
necessitate the use of beer tubes - fig. 7. A bag of 5 tubes is delivered with the
BeerTender appliance. To receive additional tubes, please contact our customer
service or go to BeerTender Internet site. (See details at the end of this manual)
WARNING:
expose to sunlight or temperatures above 30°C. Even when the keg is
empty, do not force it open and do not expose to flame or fire.

GETTING THE BEERTENDER READY

FOR YOUR OWN AND OTHERS' SAFETY, PLEASE KEEP
METICULOUSLY TO THE "SAFETY RULES".

COOLING THE BEERTENDER KEG

BeerTender kegs must be chilled before use.
■
Using a BeerTender keg that is too warm will result in too much foam.
■
There are two ways to chill the BeerTender Keg:
■
1. inside the BeerTender (see "Using the BeerTender"). It will take about
15 hours to cool the keg down to 4°C if the BeerTender Keg and the
appliance are stabilized at a room temperature of 20°C.
2. in a refrigerator. This will take about 12 hours depending on the cooling
capacity of your refrigerator.
Tip: we recommend that you always keep an extra BeerTender Keg in the
refrigerator. That way you will always have a chilled keg available.
We also recommend that you switch the appliance on at least one hour before
intended use to get full benefit from the pre-cooling of the keg.
WARNING!
bottles, a keg may burst when placed in the freezer. Moreover, freezing
diminishes the quality of the beer - fig. 29.

INSTALLING THE BEERTENDER APPLIANCE

The original packing is designed and made to protect the appliance. It is
■
recommended that you keep it for future transport.
Remove the BeerTender appliance from the packaging and place it on a
■
dry, clean, level, stable surface that is sufficiently large to accommodate it.
The temperature of the room must be between 12°C and 30°C. - fig. 4.
■
Set the drip tray and grate in place at the front of the appliance. Make sure
■
the drip tray is properly fitted and positioned.
Do not install the appliance near sources of heat or in places exposed to
■
direct sunlight.
Note: keep in mind that during use the drip tray will have to be emptied and
rinsed regularly. When the BeerTender system is not in use, you can remove
the drip tray and place it elsewhere to save space.
24
contents under pressure. Do not shake or drop. Do not
Do not attempt to chill the keg in a freezer. Just like glass