ResMed S9 AutoSet Manual De Instrucciones página 13

•
In the event of power failure
•
These S9 devices can be set to deliver pressures up to 20 cm H
fault conditions, pressures up to 30 cm H
•
Oxygen flow must be turned off when the CPAP device is not operating, so that unused oxygen
does not accumulate within the device enclosure and create a risk of fire.
•
Oxygen supports combustion. Oxygen must not be used while smoking or in the presence of an
open flame.
S9 CAUTIONS
•
Be careful not to place your device where it can be bumped or where someone is likely to trip over
the power cord.
• If you put the device on the floor, make sure the area is free from dust and clear of bedding, clothes
or other objects that could block the air inlet or cover the power supply unit.
• Make sure the area around the device is dry and clean.
•
Do not hang the air tubing in direct sunlight as it may harden over time and eventually crack.
• Do not wash the air filter. The air filter is not washable or reusable.
• The air filter cover protects the device in the event of accidental liquid spillage. Ensure the air filter
and air filter cover are fitted at all times.
•
At low pressures, the flow through the exhalation ports of your mask may not clear all exhaled gas
from the tubing. Some rebreathing may occur.
• The airflow for breathing produced by these devices can be as much as 11ºF (6ºC) higher than the
temperature of the room. Caution should be exercised if the room temperature is warmer than 90ºF
(32ºC).
H5i WARNINGS
•
The H5i is designed only for use with S9 Series devices. Do not use the H5i with any other CPAP
device.
•
Do not operate the H5i if it is not working properly or if any part of the CPAP device or H5i has been
dropped or damaged.
•
The H5i should only be used with tubing or accessories recommended by ResMed. Connection of
other delivery tubes or accessories could result in injury, or damage to the device.
•
Water must be prevented from entering your CPAP device.
1. During partial (below rated minimum voltage) or total power failure, therapy pressures will not be delivered.
When power is restored, operation will recommence with no change to settings.
1
or machine malfunction, remove the mask.
O are possible.
2
O. In the unlikely event of certain
2
13