CONTENTS | SPECial iNfOrmaTiON
OPERATION
1.
1.1
1.2
1.3
2.
Safety ����������������������������������������������������������4
2.1
Intended use ������������������������������������������������������ 4
2.2
3.
4.
Settings �������������������������������������������������������5
4.1
5.
6.
7.
Safety ����������������������������������������������������������6
7.1
7.2
7.3
8.
8.1
9.
Preparation ���������������������������������������������������6
9.1
9.2
10.
Installation ����������������������������������������������������7
10.1
10.2
10.3
11.
11.1
11.2
12.
13.
13.1
14.
Maintenance ������������������������������������������������ 14
15.
Specification ������������������������������������������������ 14
15.1
15.2
15.3
DHW output ������������������������������������������������������ 15
15.4
15.5
Pressure drop ��������������������������������������������������� 15
15.6
15.7
Test symbols ����������������������������������������������������� 15
15.8
15.9
Data table �������������������������������������������������������� 16
ENVIRONMENT AND RECYCLING
2
| PEO 18/21/24 | PEO 27
SPECial iNfOrmaTiON
- The appliance may be used by children aged 3
and older and persons with reduced physical,
sensory or mental capabilities or a lack of ex-
perience and know-how, provided that they
are supervised or they have been instructed
on how to use the appliance safely and have
understood the potential risks. Children must
never play with the appliance. Children must
never clean the appliance or perform user
maintenance unless they are supervised.
- The tap can reach temperatures of up to
60 °C. There is a risk of scalding at outlet tem-
peratures in excess of 43 °C.
- The appliance is suitable for supplying a
shower (shower operation). If the appliance
is also or exclusively used for shower oper-
ation, the qualified contractor must activate
the temperature setting range using the
temperature limit (Tred = 55 °C) in the appli-
ance. When using preheated water, it must be
ensured that the inlet temperature does not
exceed 55 °C.
- Ensure the appliance can be separated from
the power supply by an isolator that discon-
nects all poles with at least 3 mm contact
separation.
- The specified voltage must match the power
supply.
- The appliance must be connected to the earth
conductor.
- The appliance must be permanently connect-
ed to fixed wiring.
- Secure the appliance as described in chapter
"Installation / Installation".
- Observe the maximum permissible pressure
(see chapter "Installation / Specification / Data
table").
- The specific water resistivity of the mains
water supply must not be undershot (see
chapter "Installation / Specification / Data
table").
www.stiebel-eltron.com