Cleaning And Maintenance; Product Warranty - Redmond RMG-CB1210-E Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
CAUTION! The operation time should not exceed 5 minutes. A break should not be less
than 15 minutes.
You are not advised to put bones, animal skin, frozen meat or large chunks of meat
into the feed chute as it reduces the service life of the appliance and may cause a
breakdown.
See the appliance usage procedure on the corresponding schemes:
A2
• making mince —
;
A3
• making sausages —
;
A4
• making kibbeh —
.
Use of Reverse Function
Use the reverse function in case you see there is much juice left in the cutting block
or squeezer unit and a dense cake of food has blocked the outlet port.
If the squeezer is in operation at the moment, stop the rotation of the shaft by press-
ing the ON/OFF button. Then press and hold down the REV button. The screw will
turn backwards moving the foods towards the feed chute port. Release the REV
button in 10-15 seconds and then press the ON/OFF button to resume processing.
III. CLEANING AND MAINTENANCE
See the recommended methods of cleaning different appliance parts in the table A5
Clean all the attachments and parts of the squeezer right after use.
CAUTION! Switch off the appliance and unplug it before disassembling and cleaning.
Cleaning
Wipe the motor unit with a damp cloth.
Clean the attachments and other parts with nonabrasive scouring substances.
Do not clean the parts of the appliance in a dishwasher as they may tarnish being
affected by scouring substances. Do not exceed maximum temperature of 60°C while
cleaning metal parts of the appliance in a dishwasher.
Let all parts dry at room temperature and natural ventilation.
DO NOT immerse the motor drive unit, plug and power cord in water or keep in running
water.
DO NOT use sponges with hard or abrasive surface, abrasive scouring substances and
solvents (benzine, ethyl acetate and others).
Storage
Store the assembled appliance in a dry, ventilated place away from heating and direct
sunlight.
IV. BEFORE CONTACTING SERVICE CENTRE
Problem
Possible causes
Solution
Power cord is not connected
to the appliance and (or) to
Plug in the appliance
the outlet
The appliance
Plug in the appliance to the work-
d o e s
n o t
Faulty electrical outlet
ing outlet
switch on
Check the voltage supply. In case
Power supply failure
of its failure, contact an authorized
organization
Problem
Possible causes
The motor is
Press ON/OFF, unplug the appli-
working, but
ance and let it cool down for 30
Overload protection acti-
the
auger
minutes. Clean the loading tray
vated
stopped spin-
from remnants and plug in the ap-
ning
pliance
Reduce continuous operation time,
The appliance is overheated
increase intervals between switch-
An off-odour
during operation
ing
appeared dur-
ing operation
Some parts of the appliance
The odour will disappear after few
have protective cover
uses
V. PRODUCT WARRANTY
We warrant this product to be free from defects for a period of 2 years from the date
of purchase. If the appliance fails to operate properly within the warranty period and
is found to be defective in material or workmanship, we will repair or replace it free
of charge. This warranty comes into force only in case an original warranty service
coupon with a serial article number and an accurate impress of the company of the
seller proves the purchase date. This limited warranty does not cover damage caused
by the failure to use this product for its normal purpose or in accordance with the
.
instructions on the proper use and maintenance of the product, or any kind of repair
works. Do not try to disassemble the appliance and keep all package contents. This
warranty does not cover normal wear of the appliance and its parts (filters, bulbs,
non-stick coating, gaskets, etc.).
The service life and the applicable product warranty period start on the date of
purchase or the date of manufacture (if the purchase date cannot be established).
You can determine the manufacture date by the serial number located on the iden-
tification label on the housing of the appliance. The serial number consists of 13
digits. 6th and 7th digits of the serial number identify the month, 8th digit the year
of manufacture.
The service life of the product, established by the manufacturer is 3 years from the
date of purchase, provided that the unit is used and maintained in accordance with
the user manual and applicable technical standards.
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to the
applicable collection point for the recycling of electrical and electronic
equipment. Do not throw away the electronic waste to help protect the
environment.
Old appliances must not be disposed with other household waste but
must be collected separately. Municipal disposal of recyclable wastes is free of charge.
The owners of old appliances are required to bring it to a waste facility centre. With
this little extra effort, you can help to ensure that valuable raw materials are recycled
and pollutants are treated as appropriate.
This appliance is labelled in accordance with European Directive 2012/19/EU —
concerning used electrical and electronic appliances (waste electrical and electronic
equipment WEEE).
The guideline determines the framework for the return and recycling of used appli-
ances as applicable throughout the EU.
Solution
RMG-CB1210-E
GBR
9
Tabla de contenido
loading

Tabla de contenido