Garmin GHP 10 Manual Del Usuario página 3

GHP 10 Autopilot System Hydac 2.1 L Pump Installation Addendum
™
Use the GHP 10 Installation Instructions to install the GHP 10 autopilot system, and refer to these instructions to install the Hydac 2.1 L pump.
The sections covering the 2.1 L pump instructions included in the GHP 10 Installation Instructions may not apply to this pump. Read all
installation instructions before proceeding with the installation. If you experience difficulty during the installation, contact Garmin Product
Support, or seek the advice of a professional installer.
Contact Garmin
Contact Garmin Product Support if you have any questions while using your GHP 10 autopilot system. In the USA, go to
/support, or contact Garmin USA by phone at (913) 397.8200 or (800) 800.1020.
In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
In Europe, go to www.garmin.com/support
phone at +44 (0) 870.8501241.
Warnings
• You are responsible for the safe and prudent operation of your vessel. The GHP 10 is a tool that will enhance your capability to
operate your boat. It does not relieve you from the responsibility of safely operating your boat. Avoid navigational hazards and never leave
the helm unattended.
• Always be prepared to promptly regain manual control of your boat.
• Learn to operate the GHP 10 on calm and hazard-free open water.
• Use caution when operating the GHP 10 at high speeds near hazards in the water, such as docks, pilings, and other boats.
• See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Cautions
• Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
• When drilling or cutting, always check the opposite side of the surface. Be aware of fuel tanks, electrical cables, and hydraulic hoses.
Hydac 2.1 L Pump Installation Addendum
Contact Support
and click for in-country support information, or contact Garmin (Europe) Ltd. by
www.garmin.com
1