Cutout Dimensions; Drain Requirements - Haier HDBC100AFS Instrucciones De Instalación

CUTOUT DIMENSIONS

4"
(10.2 cm)
*Underside of countertop to floor.
Cut holes in the shaded area of the cabinet walls or floor for plumbing and electrical service.
NOTE: ADA installation, 321/2" (82.5) cm beneath 34" (86.4 cm) high countertops
may be accomplished by adjusting the toekick and leveling legs.

DRAIN REQUIREMENTS

•
Use the new drain hose supplied with your dishwasher. If this is not long enough,
use a new drain hose with a maximum length of 10 ft (3.05 m) that meets all
current AHAM/IAPMO test standards, is resistant to heat and detergent, use
5/8"(1.58 cm) or 7/8"(2.2 cm) inside diameter (I.D.) hose and a coupler to connect
the two hose ends. Secure the connection with two clamps
•
Connect drain hose to waste T or disposer inlet above drain trap in house
plumbing and 32" (81.3 cm) minimum above the floor. It is recommended that
the drain hose either be looped up and securely fastened to the underside of the
counter, or be connected to an air gap.
•
Use an air gap if the drain hose is connected to house plumbing lower than 20"
(50.8 cm) above the floor.
•
Use 1/2" minimum I.D. drain line fittings.
All surfaces must be free
from intrusions
17-5/8" (44.8 cm) min.
18" (45.7 cm) max.
air gap
34" to 35"
(86.4 cm to
88.9 cm)*
24"
(61 cm)
min.
6"
(15.2 cm)
7