Connect To Water Supply - Haier HDBC100AFS Instrucciones De Instalación

NOTES:
•
Insert wire ends into twist on connector. Do not pre-twist
bare wire.
•
Twist connector.
•
Gently tug on wires to be sure both are secured.
ground
6. Tighten strain relief screws to secure cord.
7. Reinstall terminal box cover with wires inside terminal box.
8. Make sure wires are not pinched by cover.

CONNECT TO WATER SUPPLY

Compression fittings:
•
Slide nut onto copper tubing about 1" (2.5 cm).
•
Slide ferrule onto the tubing. Do not position ferrule on the end of the
tubing.
•
Put the tubing into the elbow as far as it will go.
•
Slide the nut and ferrule forward and start the nut onto the elbow threads. Be
gentle when handling and positioning the copper tubing, it bends and kinks
easily.
elbow
1. To prevent vibration during operation, route the water supply line so that it does
not touch the dishwasher base, frame or motor.
2. With copper tubing pushed into compression fitting as far as it will go, use a
wrench and tighten compression fitting nut to elbow on water inlet valve. Do not
use plumbers tape with compression fittings.
3. Place paper towel under elbow. Turn on water supply and check for leaks.
22
white
black
ferrule