Water Supply Requirements; Electrical Requirements - Haier HDBC100AFS Instrucciones De Instalación

•
Do not connect drain lines from other devices to the dishwasher drain hose.

WATER SUPPLY REQUIREMENTS

•
A hot water line with 20-120 psi (138-862 kPa) water pressure.
•
120°F (49°C) water at dishwasher.
•
3/8" outside diameter (O.D.) copper tubing with compression fitting or flexible
stainless steel braided fill line (1/2" minimum plastic tubing is not recommended).
•
A 90° elbow with 3/8" N.P.T. external pipe threads on one end.

ELECTRICAL REQUIREMENTS

Contact a qualified electrician. Be sure that the electrical connection and wire size
are adequate and in conformance with the National Electrical Code, ANSI/ NFPA No.
7-latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
You must have:
•
120 volt, 60 Hz, AC-only, 15 or 20 amp., fused electrical supply
•
Wiring must be 2 wire with ground.
We recommend:
•
A time-delay fuse or circuit breaker.
•
A separate circuit.
If direct wiring dishwasher:
•
Use flexible, armored or non-metallic sheathed, copper wire with grounding
wire that meets the wiring requirements for your home and local codes and
ordinances.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dishwasher.
•
For cable direct connections the cable must be routed as shown. Cable must
extend a minimum of 24" from the rear wall.
•
For power cord connections, have a qualified electrician install a 3 prong
grounding type receptacle. The power-supply receptacle for the appliance shall
be installed in a cabinet or on a wall adjacent to the under counter space in which
the appliance is to be installed.
8