Connect To Drain - Haier HDBC100AFS Instrucciones De Instalación

CONNECT TO DRAIN

IMPORTANT: Total drain hose length must not exceed 10 ft (3.05 m), for proper
drain operation.
1. To help minimize vibration, route drain hose to avoid contact with motor, door
springs, water line, cabinet, flooring or the edge of the hole where it passes
through the cabinet.
2. Do not remove drain loop from side of dishwasher.
3. Place pad under end of drain hose. Pan will collect water in drain hose.
4. The drain hose molded end will fit 5/8" (16 mm), 3/4" (19 mm) or 1" (25.4 mm)
diameter connections on the air gap, waste tee or disposer. Cut on the marked
line as required for your installation.
NOTE: If a longer drain hose is required, add up to 42" (1.07 m) of length for a
total of 10 ft (3.05 m) to the factory installed hose.
5. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends.
Secure the connection with hose clamps.
6. Secure the drain hose to the air gap, waste tee or disposer with clamps.
cutting lines
3/4"
1" 5/8"
coupler
hose clamp
drain
hose
hose clamp
23