Haier HDBC100AFS Instrucciones De Instalación página 18

Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
1. Grasp sides of dishwasher door frame and put dishwasher on its back.
2. Remove two screws attaching toekick panel and lower panel to dishwasher using
a Phillips screwdriver.
3. Remove panels and set panels aside on a protective surface.
4. Apply thread seal tape to 90° elbow fitting and connect
fitting to water inlet valve.
5. Tighten elbow until snug, and be sure that it faces to the
rear.
6. Remove top screw and slide cover to the right to remove
terminal box cover.
NOTE: If you are direct wiring: install a U.L. - listed/CSA- conduit, use a U.L.-
listed/CSA-certified conduit connector.
7. Measure height of cabinet opening from underside of countertop to floor where
dishwasher will be installed (you need the lowest point).
16
WARNING
Excessive Weight Hazard
water inlet valve
elbow