Add Rinse Aid; Important - Kenmore Ultra Wash 665.1454 Manual De Uso Y Cuidado

Use automatic dishwasher detergent only. Add detergent
■
just before starting a cycle.
Fresh automatic dishwasher detergent results in better
■
cleaning. Store tightly closed detergent container in a cool
dry place.
To close lid
Place selected detergent in
the dispenser. Place finger, as
shown, and slide lid closed.
Press firmly until it clicks.
Powders and Gels
Water Soil Level
Hardness
Soft Light
(0-4 grains
Normal
per U.S.
Heavy
gallon)
Medium Light
(5-9 grains
Normal
per U.S.
Heavy
gallon)
Hard Light
(10-14 grains
Normal
per U.S.
Heavy
gallon)
*The prewash compartment is on top of the sliding door of
the dispenser.
**A full main wash compartment contains 2 Tbsp (30 ml).
IMPORTANT: Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener
is recommended to avoid damage and achieve good results.
NOTE: Follow instructions on the package when using other
dishwasher detergent types.
10
To open lid
Push OPEN, as shown,
and the lid will slide open.
Prewash Main Wash
Compartment* Compartment
None "Soft" fill line
None "Soft" fill line
Full "Soft" fill line
None "Soft" fill line
Full Full**
Full Full**
Full Full**
Full Full**
Full Full**

Add Rinse Aid

IMPORTANT: Your dishwasher is designed to use rinse aid. The
use of rinse aid greatly improves drying by allowing water to
drain from the dishes after the final rinse. Rinse aid also keeps
water from forming droplets that can dry as spots or streaks.
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions, this will last 1 to 3 months.
NOTE: Indicator reads correct fill level when door is
completely opened.
1. To add rinse aid, open the rinse dispenser lid by gently
pushing in the center of the lid with your thumb and pulling
up on the edge.
2. Pour rinse aid into the opening until the dispenser is full.
Do not overfill.
3. Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4. Then, close the dispenser by pushing down gently on the lid.
Rinse Aid Setting
Your rinse aid dispenser is adjustable.
For most water conditions, the factory
setting will give good results. If you have
hard water and notice calcium buildup
on your dishware, you may want to try a
higher setting. If you notice foam in your
dishwasher, use a lower setting.
To adjust the setting:
Turn the arrow adjuster to a higher number
to increase the amount of rinse aid.
Full
Add