Hdmi Output - koban KCTE-80 Manual Del Usuario

KCTE-80
Thermal Imager

7.11-HDMI Output

The video output available in the Thermal Imager enables displaying the thermal image(not includes operator
menu) on an external monitor or video recording device capable of managing HDMI systems. To connect the
Thermal Imager, proceed as follows:
1- Connect the Thermal Imager to the external HDMI monitor or recording device using the HDMI video
cable provided.
2- Turn on the external HDMI monitor or device.
3- Power on the Thermal Imager.
4- With the image displayed on the external HDMI monitor or device, the thermal imager's display works
simultaneously.
5- Once the operations on the external device are finished, Switch off the extern device and disconnect the
HDMI video cable from the thermal imager.
8-Fault Diagnosis and Exclusion
If you encounter any problems while using the thermal imager, overhaul according to the following table. If
the problem persists, disconnect the power and contact with the company's technical support department.
Phenomenon of the fault
Thermal imager cannot start
Thermal imager shut down
No Thermal image
9-PC Software
9.1-Software Install and Uninstall
System required
Window XP or higher version of Windows system, please make sure you have installed Net Framework 2.0
or Net Framework 3.5(include 2.0)when you install PCIMeter software. If not, please find and install our
Microsoft. NET_Framework_v2.0.exe that provided to you .
Open the net framework 2.0,Follow all tips to install Net Framework 2.0 till it finishes. If your system
already have installed Net Framework 2.0, then no need to install again.
Cause of the fault
No battery
No power
No power
The lens cap cover
Solution
Inserting the battery
Replace the battery or charge it
Replace the battery or charge it
Opened the lens cap
www.grupotemper.com