SN2004/AST4, SN2004/AST4-F, SN2024/AST4
Rough-In Locations for Wall Anchor Bracing
Dimensions are to determine
reinforcement locations.
Use fixture as a template
for precise location of 3/8"
anchors.
Floor-mounted units: UPC and
IPC restrict the vertical distance
from the fixture outlet to the trap
weir to not more than 24" (610).
Check state and local codes for
variances.
Rough-In Dimensions for Supplies
and Drain
Notes
Maximum flow rate required to washfountain is 1 .5 GPM . Size supply
lines accordingly .
Supplies from Below: Stub up 2-1/2" (64) .
Supplies from Above: Supplies must be located on centers of
dimensions shown to pass through washfountain shroud and
sprayhead .
Drain through floor: Stub up 3" (76) .
Supplies from Below or Through Wall
Type A
Off-line vent (P-Trap
supplied by Installer .)
2-3/4"
(70)
5"
C
(127)
C
L
4-1/2"
(114)
H
5"
(127)
When running supplies and drain through wall, use same horizontal measurements as shown in Top
View. Position openings above the finished floor, at the following dimensions (to center):
Drain: Standard Height: 19-1/4" (305)
Juvenile Height: 15-1/4" (387)
4
Type H
Centrally rising vent
(P-Trap furnished
with unit .)
Top View
2-3/4"
(70)
C
4-1/2"
(114)
4-1/2"
(114)
H
5"
(127) 9-1/4"
(235)
8/18/2014
Floor-Mounted
Units Only
(mm)
Key
Type B
Centrally rising vent
(P-Trap furnished
with unit .)
2-3/4"
(70)
C
C L
H
8-1/16"
(205)
9-1/4"
(235)
Supplies: Standard Height: 12" (305)
Juvenile Height: 8" (203)
Bradley • 215-1070 Rev. K; ECN 14-00-007
22-3/8"
(568)
10"
(254)
9"
(229)
24-3/4"*
(629)
14-3/4"*
(203)
8" Std
(203)
4-3/4"
8-3/8" Juv
(121)
(213)
* Subtract 4" (102) from
C L
this dimension for juvenile
height model.
1/2" Supply: Nominal Copper Tube
1/2" Supply Through Wall (Optional):
Nominal Copper Tube
1-1/2" NPT Drain
1-1/2" NPT Vent
Supplies from Above
Top View
2-3/4"
(70)
27/32"
(21)
C L
27/32"
(21)
8-1/16"
Installation
(mm)
32-1/2"*
(826)
Type O
Off-line vent
(P-Trap supplied
by Installer .)
27/32"
(21)
C
C
L
27/32"
H
(21)
(205)