Idiomas disponibles
Idiomas disponibles
• If the side headgear straps are lying on your ears, adjust the top headgear strap to lift the
headgear off of your ears. The headgear should lay flat against your head. If it is bunching,
adjust the top headgear strap to allow the headgear to flatten.
Removing the Mask
1. Disconnect the lower straps by removing one or both headgear
clips or detaching one or both headgear straps from the faceplate.
2. Slide the headgear off over your head. The entire headgear
stretches for easy removal.
Removing and Attaching the Cushions
To Remove
1. Pull outward on the three attachment tabs on each side of the
outer support cushion until this cushion separates from the mask
frame.
2. Remove the outer support cushion.
3. Remove the inner sealing cushion with the blue flap.
To Attach
1. Place the smaller inner sealing cushion on the mask frame (Figure
7).
Note: The blue flap must cover the lip on the mask.
2. Slide the larger outer support cushion with tabs facing downward
around the inner sealing cushion until all three sides click into the
mask frame (Figure 8).
3. Gently tug on the cushions to make sure they are securely in place.
4. Gently press the forehead pad into the forehead pad slot in the
mask frame.
Specifications
Warning:
The technical specifications of the mask are provided for your healthcare professional to
determine if it is compatible with your CPAP or bi-level therapy device. If used outside
these specifications, or if used with incompatible devices, the mask may be uncomfortable,
the seal of the mask may not be effective, optimum therapy may not be achieved, and leak,
or variation in the rate of leak, may affect device function. The pressure flow curve shown
below is an approximation of expected performance. Exact measurements may vary.
Pressure Flow Curve
70
60
50
40
30
20
10
0
0
5
10
15
Pressure cm H
O
2
20
25
4
Figure 7
Figure 8
30
