Double Insulation - Makita DTD153 Manual De Instrucciones

ENGLISH
Symbols
The followings show the symbols used for the equipment. Be sure that you understand their meaning before use.
• Indoor use only

• DOUBLE INSULATION

• Charging
• Delay charge (Battery cooling or too cold
battery)
• Conditioning
• Do not short batteries.
• Do not expose battery to water or rain.
• Only for EU countries
Do not dispose of electric equipment or battery pack together with household waste material!
In observance of the European Directives, on Waste Electric and Electronic Equipment and Batteries and Accumu-
lators and Waste Batteries and Accumulators and their implementation in accordance with national laws, electric
equipment and batteries and battery pack(s) that have reached the end of their life must be collected separately and
returned to an environmentally compatible recycling facility.
CAUTION:
1. SAVE THESE INSTRUCTIONS – This manual contains
important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2) battery, and (3)
product using battery.
3. CAUTION – To reduce risk of injury, charge only Makita type
rechargeable batteries. Other types of batteries may burst
causing personal injury and damage.
4. Non-rechargeable batteries cannot be charged with this
battery charger.
5. Use a power source with the voltage specified on the
nameplate of the charger.
6. Do not charge the battery cartridge in presence of flammable
liquids or gases.
7. Do not expose charger to rain or snow.
8. Never carry charger by cord or yank it to disconnect from
receptacle.
9. After charging or before attempting any maintenance or
cleaning, unplug the charger from the power source. Pull by
plug rather than cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
Charging
1. Plug the battery charger into the proper AC voltage source.
Charging light will flash in green color repeatedly.
2. Insert the battery cartridge into charger until it stops adjusting
to the guide of charger. Terminal cover of charger can be
opened with inserting and closed with pulling out the battery
cartridge.
3. When the battery cartridge is inserted, the red charging light
will light up and charging will begin with a preset brief melody
sound coming out for assurance as to which sound will come
out to notify the completion of charging.
Changing melody of completed charging
1. Inserting the battery cartridge into charger brings out last
preset brief melody sound of completed charging.
2. Removing and re-inserting it within five seconds after this
action makes the melody sound change.
3. Every time removing and re-inserting it within another five
seconds after this, the melody sound changes in order.
4. When the desired melody sound comes out, leave the battery
cartridge being inserted and the charge will begin. When a
"short beep" mode is selected, no completed charging signals
comes out. (Silent Mode)
2
• Read instruction manual.
• Ready to charge
• Charging complete
• Deffective battery
• Cooling abnormality
• Do not destroy battery by fire.
• Always recycle batteries.
11. Do not operate charger with damaged cord or plug. If the cord
or plug is damaged, ask Makita authorized service center to
replace it in order to avoid a hazard.
12. Do not operate or disassemble charger if it has received a
sharp blow, been dropped, or otherwise damaged in any way;
take it to a qualified serviceman. Incorrect use or reassembly
may result in a risk of electric shock or fire.
13. This appliance is not intended for use by persons (including
children) with reduced
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
14. Children should be supervised to ensure that they do not play
with the battery charger.
15. Do not charge battery cartridge when room temperature is
BELOW 10°C (50°F) or ABOVE 40°C (104°F). When the
battery temperature is under 0°C (32°F), charging may not
start.
16. Do not attempt to use a step-up transformer, an engine
generator or DC power receptacle.
17. Do not allow anything to cover or clog the charger vents.
4. With finish of charge, the charging light will change from red
one to green one and the melody sound or buzzer sound (a
long beep) comes out to notify completion of charge.
5. Charging time varies by temperature (10°C (50°F) – 40°C
(104°F)) that battery cartridge is charged at and conditions of
the battery cartridge, such as a battery cartridge which is new
or has not been used for a long period of time.
6. After charging, remove the battery cartridge from charger and
unplug the charger.
5. With finish of charge, the green light remains lit with the red
light going out and the melody sound preset at the insertion of
battery cartridge or buzzer sound (a long beep) comes out to
notify completion of charge. (In selected silent mode, no
sounds come out.)
6. Preset melody sound remains stored even when the charger
is unplugged.
physical, sensory or mental