Switching On The Control Unit; Adjusting The Rotational Speed; Adjusting The Torque Limitation - Nouvag TCM Endo V Instrucciones De Uso

TCM Endo V
C) Button "▲":
Increase speed or torque.
D) Button "Auto control":
Selection of mode which is activated when the adjusted distance of the file to the Apex has been
reached.
E) Button "Apex adjust":
Adjustment of distance to Apex for which the selected mode is activated.
F) Button "Motor":
Switch on-off (LED is illuminated when motor is switched on!).
→ Button only works if device is operated without footpedal!
G) Button "ATC":
Display switches over: Rotational speed / torque limitation.
H) LED "Auto Slow/Down", "Auto Reverse" and "Auto Stop":
Display of current Auto-Control-Modus → LED illuminated if relevant mode activated!
I) LED long bar:
Displays current distance from tool tip to Apex (1LED = 0.1mm).
J) LED short bar:
Displays distance at which the adjusted Auto-Control-Mode is activated (1LED = 0.1mm).

7.3 Switching on the control unit

The control device can be switched on or off with the main switch (at the back!).

7.4 Adjusting the rotational speed

1) If necessary, switch over to speed display "ATC" in the display.
2) Select desired rotational speed with "▼" and "▲".
F F F F
Adjustable speed values:
150, 200, 250, 300, 350, 400, 450, 500, 600, 700, 800, 900, 1000, 1200, 1400, 1600, 1800
and 2000 [rpm].

7.5 Adjusting the torque limitation

The Automatic Torque Control (ATC) is a special function to prevent file breakage. Once the
preselected torque limit has been reached, the motor switches to reverse for one revolution. After one
revolution of the file, it returns to forward motion automatically.
Values in the display are always to be indicated in Nmm (e.g. the file is stressed with a maximum of
[AP 20] →20 Nmm).
1) If necessary switch to torque display in the display with "ATC" (e.g. [AP 20] ).
2) Select desired torque with "▼" and "▲".
8
NOUVAG AG
No. 31943 35/05