Tabla de contenido
Idiomas disponibles
Idiomas disponibles
YAKIMA Q TOWERS: DO NOT REPOSITION YOUR TOWERS!
REMOVE BASE SCREW.
Use hex wrench.
FACTORY BARS:
CHECK FOR PROPER SCREW LENGTH.
• Some factory bars may require
the long bail screws.
• Screws must extend below bail.
WORK ON A FLAT SURFACE.
Open carrier (they open two ways):
LIFT BOTTOM OF BUTTON...
1033546D-2/18
CROSSBAR
SPREAD
IF SCREWS ARE TOO SHORT, USE
THE LONGER SCREWS INCLUDED.
-OR-
PUSH TOP OF BUTTON...
SKIS AND BOARDS
UNDER 170 cm:
Crossbar spread must be
between 12" (30cm) and 24" (61cm)
SKIS AND BOARDS
Crossbar spread must be
between 12" (30cm) and 36" (91cm)
REMOVE ONE BAIL SCREW.
• Use hex wrench.
• Loosen the remaining
screw, but leave it in place.
In some cases, the bails
OVER 170 cm:
may not be parallel.
OK
OPEN
Tabla de contenido
