Makita DTD170 Manual De Instrucciones página 12

Procedure 1
For tool without one-touch type sleeve
►
Fig.12: 1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the
direction of the arrow and insert the driver bit into
the sleeve as far as it will go.
Then release the sleeve to secure the driver bit.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
Procedure 2
In addition to Procedure 1, insert the bit-piece into
the sleeve with its pointed end facing in.
►
Fig.13: 1. Driver bit 2. Bit-piece 3.
Sleeve
To remove the driver bit, pull the sleeve in the
direction of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep
enough into the sleeve, the sleeve will not return
to its original position and the driver bit will not be
secured. In this case, try re-inserting the bit
according to the instructions above.
NOTE: When it
difficult to
driver bit,
sleeve and insert it into the sleeve as far as it will
go.
NOTE: After inserting
driver bit,
that it
firmly secured.
comes out,
use it.
Installing hook
►
Fig.14: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the
tool. This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a
screw. To remove, loosen the screw and then take
it out.
OPERATION
►
Fig.15
The proper fastening torque may differ depending
upon the kind or
the screw/bolt, the
material of
workpiece to be fastened, etc. The
relation between fastening
fastening time
shown in
figures.
is
insert the
pull the
the
make sure
is
If it
do not
size of
the
torque and
is
the
12 ENGLISH
Proper fastening torque for standard bolt
N• m
( kgf•cm )
140
(1428)
120
(1224)
100
(1020)
80
(816)
2
60
(612)
40
(408)
M8
20
(204)
0
1. Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
N• m
( kgf•cm
)
200
(2040)
180
(1836)
160
(1632)
140
(1428)
120
(1224)
100
2
(1020)
80
(816)
60
(612)
40
(408)
20
(204)
0
1. Fastening time (second) 2. Fastening torque
Hold the tool
place the
the driver
the screw
forward pressure
tool to
will not slip off the screw and turn the tool on to start
operation.
NOTICE:
If you use a spare battery to continue
the operation, rest the tool at least 15 min.
NOTE: Use the
for the
the screw/ bolt that you wish to use.
NOTE: When fastening M8
smaller screw,
M16
M14
M16
M12
M14
M10
M12
M10
M8
1 2
1
M14
M14
M12
M10
M12
M8
M10
M8
1 2 3
1
firmly and
point of
bit in
head. Apply
to the
the extent that the bit
proper bit
head of
or
carefully adjust