Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting Up Safely and Putting Into Operation
IMPORTANT! Prior to starting up, check that the voltage specifications
of the laminator correspond to those of your power supply network
(220 V - 240 V, 50 Hz). Otherwise, it is possible that the laminator will
not work properly.
1. Set the laminator down on a level, stable working surface close to an
easily accessible power socket.
2. Plug the power cable into the power connector on the laminator and
to a mains power socket.
3. Switch the
Power switch
Laminating
During hot lamination, the laminating pouch is heated to a high temper-
ature as it passes through the laminator rollers. This creates a permanent
thermal bonding of the laminated material and the laminating pouch. Hot
lamination permanently prevents the laminated material from coming into
contact with water, oxygen and bacteria.
The laminator can process all cold and hot laminating foils in the thick-
nesses 80 µ, 100 µ, 125 µ, 150 µ, 175 µ and 250 µ.
Various foil thicknesses can be selected by pressing the
5
button the respective number of times. The foil thickness select-
(MIC)
ed is indicated by the blue control lamps in the status indicator
The READY control lamp in the status indicator
when the heat-up phase is completed and the laminator is ready to
operate.
1. Press the
POWER
2. Use the
Foil Thickness (MIC)
tion or to select the foil thickness for hot lamination and then wait until
the READY control lamp lights up green continuously.
3. Place the material to be laminated inside the laminating pouch. For
an optimal lamination result, leave an all-round spacing of 3 to 5 mm
from the edges of the pouch.
4. Feed the prepared laminating pouch with the closed side first, keeping
it straight, into the
as a basic orientation.
aid
9
Setting Up Safely and Putting Into Operation
to ON.
3
4
button.
button to set COLD for cold lamina-
5
of the laminator. Use the
infeed
10
G
Foil Thickness
8
lights up green
8
Positioning
.
17
Capítulos
Tabla de contenido
