Cleaning And Servicing; Troubleshooting - Olympia A 235 Manual Del Usuario

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the process
several times.
Disconnect the power plug before starting to clean the unit with a damp cloth.
If necessary, the housing can be cleaned using a cloth moistened with clean
water with a little mild soap applied. Never use any solvents or aggressive
cleaning agents.

Troubleshooting

Fault
• Red LED (POWER) does not light
up
• Unit does not respond
• Foil jam
• Laminated foil is not completely
transparent
Corrective measures
• Check that the power plug has been
properly connected to the power
socket.
• If the fault cannot be cleared, con-
tact our hotline.
• Check the foil pockets being used
are the correct size.
• Only use pouches of the size speci-
fied.
• Ensure that the pouch has been in-
serted correctly in the unit.
• To clear the fault, follow the instruc-
tions in the Section "Clearing Foil
Jams".
• Laminate the same foil again to im-
prove the lamination result.
• If thicker foil is used (100 μm,
125 μm), please allow the device to
heat up longer.
Conformity of the equipment to the
EU directives is confirmed by the
CE symbol.
20