Changing The Relay Activation Time; Configuring User Codes - SOMFY VSYSTEMPRO Manual De Instalación Y De Uso

3.3 Changing the relay activation time

See the procedure described in Section "3.2 Configuring the relay activation time"
3.4 Configuring user codes
The user codes (UC) enable you to choose which relay is activated, it is possible to store
up to 99 user codes.
The user codes must consist of 4 to 8 figures.
The first figure should be "0", "1", "2" or "3" as it determines the relay to be
activated, for example:
0 1 2 3
1 1 2 3
2 1 2 3
3 2 3 4
To facilitate the management of user codes (UC), those corresponding to usage
numbers (UN) consist of 2 digits. The table at the end of the document enables the
user codes allocated to each usage number to be noted.
A single user code can correspond to more than one usage code.
When configuring user codes, the usage number first needs to be entered (2 digits),
then the corresponding user code (4 to 8 digits).
See diagram P3 at the end of the document.
Key:
Abbreviation
CM1
UN
UC
Beeping
sound (*)
(1)
Note: If a user code has already been stored on a usage number, entering using the same
usage number clears the old user code and stores the new one.
4 5 6 7 Activates relay 1
5 6 7 8 Activates relay 3
Meaning
Existing master code
Usage number: 2-digit number
User code: number between 4 and 8 digits
The keypad emits a beeping sound instead of a little tune to indicate
an input error (a single digit for example): in this instance, the correct
parameter needs to be entered again in order to be able to continue
the procedure.
At this stage, the user code is stored with its usage number. It is then
possible to enter another user code or to exit the procedure.
Copyright © 2016 Somfy SAS. All rights
Activates relays 1 and 2
Activates relay 2
reserved.
EN
8