Assembling The Handle Tube; Operating The Vacuum; Storage; Operating Instructions - Oreck HEPA Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operation
4
E
N

Assembling the Handle Tube

Align slot in handle tube with tab in connector.
1
Insert the handle tube into connector. Tighten
collar at base of handle tube onto the connector
until it locks, "snaps".
2
Snap cord assembly into the cord clip located
on the left side of the collar. Leave excess cord
at the power head to allow movement.

Operating the vacuum

Make sure the Disposable Odor Fighting HEPA Inner bag is in place. DO NOT operate the cleaner without a HEPA
Inner bag. Plug the power cord into an electrical outlet and press the On Low ( l ) - On High ( ll ) - OFF ( O )
switch on handle assembly when ready to operate.
Up-Position Lock -
3
Place foot on power head and lean handle back gently to release lock for vacuum
use. Return handle to the full upright position to engage lock. The handle should be rotated to center before
returning to upright position. Note: Do not operate the unit while in the upright and locked position. Do not
let the unit run while in any one stationary position for any period of time. Keep the unit moving while in
operation.
Carry Handle -
4
Raise the carry handle located on back of the unit for easy lifting, carrying, and stair
vacuuming. Lower the handle during use to eliminate obstruction.
Easy Power Cord Storage -
5
and vacuum handle.
6
To release cord, twist cord dump located on vacuum handle 1/2 turn. Slide cord off handle.

Storage

Both the vacuum handle and carry handle can be used for convenient, space saving storage of cleaner.
Hang cleaner by carry handle on a sturdy fastener or vacuum handle on a closet rod.

Operating Instructions

This new ORECK Upright is one of the finest, fastest, and strongest units in its class. You'll love the way it
cleans, gets under things, and it's SO lightweight and easy to use.
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable HEPA inner bag -FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable HEPA inner bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and
service.
4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor
suction fan and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum
cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under
warranty.
6. For optimal performance, replace the belt every 6 months.
7. Check the disposable Odor Fighting HEPA Inner bag at least once a month.
8. DO NOT run the vacuum cleaner over the cord. The revolving brush could damage the cord.
9. Use caution when vacuuming over area rug edges and fringe.
G
L
I
S
H
Raise carrying handle and wrap power cord around carry handle
3
4
1
2
5
6
Tabla de contenido
loading

Tabla de contenido