Electrical Connection; Operating Checks; Disposal Of Old Electrical Appliances - THERMEx CHIMNEY Instrucciones De Uso Y Mantenimiento

3.2 - SAFETY
Do not connect the appliance discharge to exhaust
•
ducts of smokes produced by combustion that is
not supplied by electrical power.
The minimum safety distance between the
•
cooking counter and the hood is 65 cm.
Arrange proper ventilation if other appliances
•
besides the hood, which are not supplied by
electrical power, are being used in the same
room. Proper use without risks is obtained when
the maximum depression of the room does not
exceed 4 Pa (4x0 bar).
3.3 - COMPONENTS (Fig.2)
 - Support clamp for hood casing
2 - Hood telescopic casing
3 - Bag with accessories and screws
4 - Engine Unit
5 - Flexible tube in stainless-steel
6 - Hood body
3.4 - INSTALLATION
�a�e the holes for �all-fixing that correspond �a�e the holes for �all-fixing that correspond
•
with the centre of the hob: follow all indications
carefully. (Fig.5)
Insert four plugs into the wall (2 to hang the hood Insert four plugs into the wall (2 to hang the hood
•
and 2 for safety holes). (Fig.6)
Fix the hood firmly to the �all using the �� scre�s�� Fix the hood firmly to the �all using the �� scre�s��
•
(Fig.7)
Connect cable with fast connector on the motor Connect cable with fast connector on the motor
•
group. (Fig 8)
Insert the ��exible tube �Fig����� bet�een motor Insert the ��exible tube �Fig����� bet�een motor
•
group and the body of the hood. Pass the cable
in the foreseen hole.
Grip the 4 screws on both sides. (Fig.0) Grip the 4 screws on both sides. (Fig.0)
•
Fix the stainless steel connection support clamp Fix the stainless steel connection support clamp
•
to the wall using the 2 supplied screws. (Fig.
)
Adjust the height so that the lower part of the Adjust the height so that the lower part of the
•
hood, which is to be assembled afterwards,
is arranged at least 65 cm from the cook top.
(Fig.2)
Insert the chimney lin�s in stainless steel first Insert the chimney lin�s in stainless steel first
•
the shorter and then the longer part, passing
the electical cable on to the side of the switch.
Lift the stainless steel internal connection and Lift the stainless steel internal connection and
fix it to the clamp using the 2 scre�s�� �Fig��13��
3LIOPS.2

3.5 - ELECTRICAL CONNECTION

Check that the mains voltage complies with the
that required by the hood.
This is indicated on the plate that is applied inside
the appliance.
A plug vin compliance with norms and .5 mt. of
cable are supplied.

3.6 - OPERATING CHECKS

Check lights and motor start-up on all 4
speeds.
4 - CARBON FILTERS 'HER' (Fig.4)
4.1- CAUTION
Unli�e traditional carbon filters, this carbon filter
can be washed and reactivated.
With normal hood use, the filter should be
cleaned once a month�� The filter is best �ashed in
a dishwasher at the highest temperature possible,
using a normal dishwasher detergent.
To avoid particles of food or dirt setting on the
filter during �ashing and giving rise to unpleasant
smells, it is advisable to �ash the filter on its o�n��
After �ashing, dry the filter in the oven at 100°C
for 10 minutes to reactivate it�� The filter �ill retain
its odour absorbing capacity for three years, after
which it will have to be replaced.
5 - SpECIFICATIONS
5.1- CONSTRUCTION CHARACTERISTICS
- STAINLESS STEEL SHEET STRUCTURE T
- HOOD WITH TELESCOPIC FLUE WITH
ADJUSTABLE HEIGHT
5.2 - GENERAL CHARACTERISTICS
- ELECTRICAL SYSTEM ACCORDING TO THE
INTERNATIONAL REGULATIONS
- 4 OPERATING SPEEDS
- LIGHTING: dichroic light bulb, 50W 2V GU
5.3
DISpOSAL OF OLD ELECTRICAL AppLIANCES
The European Directive 2002/96/EC on
Waste Electrical and Electronic Equipment
(WEEE), requires that old household electri-
cal appliances must not be disposed of in
the normal unsorted municipal waste
stream. Old appliances must be collected
separately in order to optimise the recovery and recy-
cling of the materials they contain and reduce the impact
on human health and the environment.
The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose
of the appliance it must be separately collected.
Consumers should contact their local authority or
retailer for information concerning the correct disposal
of their old appliance.
EN
7