General Information - THERMEx CHIMNEY Instrucciones De Uso Y Mantenimiento

EN USE AND MANTAINANCE INSTRUCTIONS
1 - USE INSTRUCTIONS
1.1-CONTROL PANEL (Fig.)
A - Lighting
B - Press this to switch on the hood at speed
4. Press it again to reduce speed until it
switches off.
C - Display
D - Press this to switch on the hood at speed .
Press it again to speed up until speed 4 and
then to switch-off.
E - Timer - this button activates the timer which
will switch off the aspiration engine after 0
minutes.
F - Optional remote control (Fig.)
1.2 - SAFETY
• Do not cook at the flame under the hood.
• Constantly check oil overheating while using
the deep fryer in order to prevent it from
catching fire.
• Before carrying out any cleaning operation
disconnect the appliance by unplugging it or
by switching off the circuit breaker.
• In the case in which the hood and other
apparatuses that emit fumes are being used
in the room, do not supply with electric
energy. The room needs to be aerated.
• Do not leave the cooker on if it is not being
used.
• The hood has been designed to remove the
kitchen smells; any other additional use shall
be regarded as non-intended.
• It is advisable to turn on the hood a bit
before starting to cook and leave it on for
approx. 15 minutes after or at least until the
smell is completely removed.
1.3 - CLEANING
• Use only a damp cloth with neutral liquid
detergent.
• Do not use wet sponges or cloths, water
jets, thinners, solvents, alcohol or abrasive
substances.
6
2 - MAINTENANCE
2.1 - WARNING
Unplug the appliance or switch off the circuit
breaker before carrying out maintenance
operations.
2.2 - CLEANING THE METAL ANTI-GREASE
FILTERS (Fig.3)
For better functioning of the anti-grease filters,
•
they must be washed at least once a month.
Filters are dishwasher safe.
•
The filters may change colour slightly and
become opaque. Their functioning remains
unaltered.
If washed by hand, leave them to soak in boiling
•
water and washing-up liquid for a few hours.
Do not use brushes to clean the filters, as this
•
may ruin the texture of the structure.
If the filters are extremely dirty and grease
•
residues are present, the filters could catch fire,
therefore jeopardising the correct functioning of
the appliance.
Turn the knob to disassemble.
•
2.3 - LIGHTING (Fig.4)
To replace the light bulb:
Remove the bulb.
•
Replace the lamp with one that has the same
•
features because one with major power
may cause severe damage to the electrical
system.
3 - INSTALLING INSTRUCTIONS

3.1 - GENERAL INFORMATION

This hood is prepared to be installed above a
hob by fixing it to the wall.
We suggest to have installation carried out
by qualified personnel, in compliance with all
the current regulations and in particular with
the ones concerning air exhaust.
The manufacturer cannot be held liable for
damages caused by improper installation or
if it has not been carried out according to the
state-of-the-art.
3LIOPS.2