Kamikaze KV 360 Manual De Uso página 81

ELECTRIC PRUNING SHEARS
K. Screw the M5 hexagon socket
countersunk head counterclockwise
as shown.
15.4. TOOL CALIBRATION
If a replacement motor or drive plate is required, the pruners need to be
recalibrated.
Follow next steps to perform the calibration:
• Remove the upper and lower blades.
• Insert the battery.
• Hold down the trigger and keep it pressed. Press the POWER switch again.
• Maintain the trigger pressed for more than 10 s.
• Release the trigger when you hear the motor turning.
• The electric motor rotates during calibration. When the motor stops turning
the calibration is complete.
• Reassemble the blades as indicated in chapter 15.3.
K
L. Reduce the friction between the
two plans of the blades by adding
grease through the hole of the
plastic cap as shown in the figure.
81
www.kamikazevolpi.com
L