Working Environment; Assembly; Operations Start Procedure - Kamikaze KV 360 Manual De Uso

ELECTRIC PRUNING SHEARS

11. WORKING ENVIRONMENT

• Keep temperature of environment at 10°C ~ 22°C when charging battery,
0°C ~ +45°C when battery is working.
• Keep tool at temperature of 0°C ~ +60°C when working
• Do not use in explosive atmosphere or near flammable substances or gases.
• Do not use in case of rain or on wet branches

12. ASSEMBLY

Check that the pruning shears and batteries
are clean and dry, and then place the battery in
the battery compartment on the pruner.

13. OPERATIONS START PROCEDURE

Please wear suitable cloth and glove when operate this tool.
Always check tools before use, make sure on/off switch and safe
switch are all ok. The power should be put off when you loosen the
trigger. Stop using the tool in case of switch failure. Always check rated
voltage of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure
blade stop fully before touch it, otherwise blade will hurt your body.
• Press the power switch. After warning tone, please pull the trigger two
times without holding. Do not overload cutting, it will protect pruning
shear and battery not be damaged. Do not cutting over the dimension
specified in the technical information table.
• User just loose trigger when the blade has been jammed by branch, the
blade will resume maximum position.
73
www.kamikazevolpi.com