Assembly And Adjustment - Black and Decker Li2000 Manual De Instrucciones

INSERTING AND REMOVING BITS
• Before installing or removing bits, move the
(FIGURE C)
forward/ reverse slider (1) to the center
"lock-off" position as shown in insert.
• To install a bit, insert it into the cavity in the
hex spindle as shown in figure C.
• To remove the bit pull it straight out.
• For bit tips, use a bit tip extender as shown.
NOTE: Only hex end bits will fit in spindle.
PIVOTING THE TOOL HANDLE
• The handle of the tool can be pivoted into
(FIGURES D, E)
three positions for optimum versatility as
shown in figure D.
• To pivot the tool handle, press the pivot
release button (2) as shown in figure E.
• Release the button in any one of the two
remaining locked positions.
WARNING: Check to make sure tool
handle is locked after pressing pivot
release button and changing screwdriver
positions.
• To avoid being pinched at the areas
WARNING:
indicated with black arrows, hold the
screwdriver at both ends and use your
thumb to depress the pivot release button when changing positions.
• Do not use screwdriver as a pry bar in any position.
• To avoid screwdriver being turned on accidentally, do not carry in your pocket.
OPERATING IN POWER MODE
Forward
• Rotate the collar (4) to the position marked
• Slide the forward/reverse switch (1) to the right, exposing the arrow pointing forward as shown in figure F.
• Press the button on the switch and the tool will run; release the button and the tool will stop.
Reverse
• Rotate the collar (4) to the position marked
• Slide the forward/reverse switch (1) to the left, exposing the arrow pointing backward.
• Press the button on the switch and the tool will run; release the button and the tool will stop.

ASSEMBLY AND ADJUSTMENT

OPERATING INSTRUCTIONS
C
1
D
E
as shown in figure F.
as shown in figure F1.
7
2