Tabla de contenido
Idiomas disponibles
Idiomas disponibles
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
WARNING: Use of this tool can generate and/or disperse dust, which may cause
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
WARNING: ALWAYS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
CERTIFIED SAFETY EQUIPMENT:
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
The label on your tool may include the following symbols.
SYMBOLS
V ..........................volts
Hz ........................hertz
min ........................minutes
........................direct current
.................... Class II Construction
........................safety alert symbol
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
25 ft.
Total Length of Cord
7.6 m
15.2 m
18
Wire Size AWG
SAFETY WARNINGS AND INSTRUCTIONS: BATTERIES
• Do not disassemble or open, drop (mechanical abuse), crush, bend or deform, puncture,
or shred.
• Do not modify or remanufacture, attempt to insert foreign objects into the battery,
immerse or expose to water or other liquids, or expose to fire, excessive heat including
soldering irons, or put in microwave oven.
• Only use the battery / tool with a charging system specified by the
manufacturer/supplier.
• Do not short-circuit a battery or allow metallic or conductive objects to contact both
battery terminals simultaneously.
• Dispose of used batteries promptly according to the manufacturer/supplierʼs instructions.
• Improper battery use may result in a fire, explosion, or other hazard.
• Battery / tool usage by children should be supervised.
SAFETY WARNINGS AND INSTRUCTIONS: CHARGING
1. This manual contains important safety and operating instructions.
2. Before using battery charger, read all instructions and cautionary warnings on battery
charger and product using battery.
charger only with this product. Batteries in other products may burst causing personal
injury or damage.
50 ft.
75 ft.
22.9 m
18
16
A..........................amperes
W ........................watts
n o ........................no load speed
........................earthing terminal
.../min ..................revolutions
100 ft.
125 ft.
30.5 m
38.1 m
16
14
CAUTION: To reduce the risk of injury, use this
4
......................alternating
current
per minute
150 ft.
175 ft.
45.7 m
53.3 m
14
12
Tabla de contenido
